2.
Selecting MM setting:
Locate the jumpers L MC SEL (J101) and R MC SEL (J201:) These are two
small black jumpers located on the TP2.5 PC board on the left hand side of
the board marked JP101 and JP201. To set the preamplifier for MM
cartridges, lift the black pin jumper and connect the jumper a single pin of the
header. Do this for both jumpers (one per channel) in locations JP101 and
JP201.
3. Selecting MM load:
Locate the MM load positions marked L TX SEL and R TX SEL. You can
select the Load for either 47K or 100K. When the jumper is connected across
both pins, the load is set to 47K. When the jumper is connected to one pin
only, the load is set to 100K.
TP2.5 Preamplifier Owner’s Manual
VTL
9
