The
Status toggle
switch is a 3-position toggle switch to allow you to switch the
phono preamplifier between operating mode, the mute state and Rumble on state.
When the toggle switch is in the middle position, the preamplifier is in its operating
state. Change the preamplifier to the mute state by pressing the switch down. If
the preamplifier is currently in mute state, press this switch up to change the
system back into the operating state.
When the status switch is in the up position, the
Rumble
feature is selected.
The
Status
LED indicates whether the preamplifier is in operating state or in muted
state. When the LED light is on, the preamplifier is in operating state. When the
LED light is on and flashing, the preamplifier is in mute state. The LED is off
when the preamplifier is powered off.
The
Power On/Off
switch can be used to turn the preamplifier on and off. Press the
switch up to turn the preamplifier ON and press the switch down to turn the unit
OFF. The
Status
LED should be on and off respectively, according to the setting
of the
Power On
switch.
The Preamplifier’s Back Panel
From the Preamplifier’s back panel, you can access the input, output, ground and
power connectors, the main fuse holder, the serial number, and the voltage setting of
the unit.
RISK OF ELECTRIC SKOCK
1A Slo Blo (120V)
4/10 A Slo Blo (240V)
AC POWER
TP2.5 Phono Preamplifier
For continious protection
against fire hazard replace only
with fuses of same type and rating.
To prevent electric shock DO NOT remove cover.
No user servicable parts inside. Refer servicing
to qualified personnel. To prevent fire or shock
do not expose this appliance to rain or moisture.
Manufactured by:
VTL Amplifiers Inc.
4774 Murrieta Street Suite 10
Chino, CA 91710 USA
(909) 627-5944
Output
Inputs
MM
MC
Left
Right
GND
AC INPUT
FUSE HOLDER
INFORMATION LABEL
OUTPUT RCA'S
MM INPUT RCA'S
MC INPUT RCA'S
GROUND CONNECTOR
Connecting Your Phono Preamplifier to your
system
1.
Connect the turntable to the TP2.5 preamplifier.
Make sure that the
preamplifier and the turntable is powered off. Connect the output cable from the
turntable to either the
MM
or
MC
Input
connectors of the TP2.5 preamplifier,
TP2.5 Preamplifier Owner’s Manual
VTL
5
