![background image](http://html1.mh-extra.com/html/vtech/vh6212/vh6212_user-manual_1054343031.webp)
26
Registering Headset to Dongle
Register your Headset to the Dongle
The VH6212 headset comes pre-registered to the Dongle. If, for
some reason, the headset is not registered to the Dongle, follow
the instructions below to register your headset to the Dongle.
1. Make sure the battery is properly installed in the headset. The
headset
LED
light flashes slowly in red and blue to indicate the
headset is not registered.
2. Place the headset in the charger cradle and allow it to charge for
at least one hour before beginning registration.
3. Remove the headset from the charger cradle.
4. Press and hold the pair button on the Dongle for about four
seconds until the Dongle LED light on flashes red very quickly,
and then release the button.
5. Return the headset to the charger cradle for registration. The
headset
LED
light alternates quickly in red and blue.
It takes about 60 seconds to complete the registration process.
Once the headset is registered, the headset
LED
light turns red
when the battery is low and being charged, or turns purple when
the battery is well charged, or turns blue when the battery is fully
charged.
If the registration fails, you hear the voice prompt
"Not registered"
when you press the headset
ON/OFF
button on the headset,
and the headset
ON/OFF
button light on the headset alternates
slowly in red and blue.
To reset the headset, remove it from the charger cradle and try the
registration process again.
NOTE
• You cannot register a headset if another system headset is in use.
Appendix