43
Appendix
California Energy Commission battery charging
testing instructions
This cordless headset is set up to comply with the energy-conserving standards right
out of the box. These instructions are intended for California Energy Commission (CEC)
compliance testing only. When the CEC battery charging testing mode is activated, all
headset functions, except battery charging, will be disabled.
If you have registered the cordless headset to the
VH6212
Dongle, below are the testing
instructions.
To activate the CEC battery charging testing mode:
1. Unplug the headset charger power adapter from the power outlet. Make sure the
headset is plugged with charged battery before proceeding.
2. Press and hold the pair button on the Dongle for about 10 seconds until the Dongle
LED light flashes quickly in red, and then release the button.
3. Immediately press the pair button again. The Dongle LED light will turn steady green
for 3 seconds, and then turn off.
4. Immediately press the pair button once again.
It takes up to one minute to complete the deregistration process. The
LED light turns
steady red when the deregistration process is successful.
NOTE:
When the headset fails to enter this mode, repeat all the steps mentioned above.
To deactivate the CEC battery charging testing mode:
•
Register the headset back to the Dongle.
If you have registered the cordless headset to a compatible VTech DECT cordless
telephone, please refer to the respective user's manual for the activation and deactivation
of CEC battery charging testing mode.
If you have registered the cordless headset to a telephone base that does not have CEC
battery charging testing mode, all telephone functions on the cordless headset, except
battery charging, will be disabled.