65
Appendix
Replace a handset/headset
If you want to replace a headset or handset, or reassign the designated
handset number of a registered handset, you must deregister all the handsets
and headset that are registered to the telephone base. Then register each
handset and headset individually.
To make deregistration easier, read all of the instructions on this page before
you begin.
To deregister all handsets and headset:
Press and hold
/FIND hANDSET
on the telephone base for about
10 seconds until the
IN USE
light on the telephone base turns on and starts
to flash. Then release
/FIND hANDSET
.
Immediately press and release
/FIND hANDSET
again while the
IN USE
light is still flashing. The
IN USE
light flashes for approximately
seven seconds.
The deregistration process takes up to 10 seconds to complete. There
is a confirmation tone from the telephone base. When the deregistration
completes, all handsets display
1.Press FIND hS on base 4sec
and
2.Then press # on handset
alternately, and the headset light flashes
slowly and alternately in red and blue.
If the deregistration process is successful, you hear “
Not registered
” through
the headset earpiece when you press on the headset. If deregistration fails,
you may need to reset the telephone and try again.
To reset:
Pick up the registered handset. Press /
FLASh
and then press
OFF/
CLEAR
.
Place the handset in the telephone base.
Pick up the registered headset and press the
RESET
inset button with a
paper clip or similar object.
-OR-
Unplug the power from the telephone base, then plug it back in.
1.
2.
3.
1.
2.
You cannot deregister all handsets and headset if any system handset or
headset is in use.
