13
Making Calls- - - - - - - - - - - - - - - - - - -
1. Pick up the handset and press
PHONE
.
2. When you hear a dial tone, dial the
number.
3. The indicator for
IN USE
(on the base
unit and handset) will light. If you
make a mistake when dialing, press
OFF
to hang up, then press
PHONE
to
get the dial tone again.
You must always press
PHONE
before you can dial a call on the handset.
Answering Calls
1. When an incoming call is ringing, the
IN USE
LED in the base and the
IN USE
LED
in the handset will flash. To make sure your phone rings when the handset is away
from the base, please keep the base antenna in the upright position.
2. To answer a call when the handset is in the base, just pick up the handset.
3. To answer a call when the handset is away from the base, just press any key on the
handset (EXCEPT OFF). This is very useful in a dark environment; you do not have
to fumble around looking for the
PHONE
key to answer the call.
Disconnecting
To end a call, either place the handset
back in the base, or press
OFF
on the
handset.
Changing Channels- - - - - - - - - - - - -
If you notice interference when using
your handset, press
CHAN
to switch to a
clear channel. This function is only
available when you are on a call.
TONE/ PULSE Setting
If you have touch tone service on your
line, Press
PROG
,
*
,
*
,
MEM
to switch to
TONE dialing. If you have rotary service,
press
PROG
,
*
,
#
,
MEM
to switch to
PULSE dialing.
NOTE
: Your
VT9151/VT9155
is preset
at the factory for TONE dialing.
OPERATING INSTRUCTIONS
MAKING CALL
and
ANSWERING CALL
TO END
THE CALL
CHANGING
CHANNELS
TONE / PULSE
Setting
