www.vsv-group.com
21
6 – PUTTING INTO OPERATION
FILLING OF SWIMMING POOL
Once again check connection of all pipes (see Section 3. "Installing and Connection") and start to fill the
pool by water. Stop filling when the water reaches a level
1 cm
below the upper edge of the skimmer
(see "Connecting to the water network).
PLEASE OBSERVE THE FOLLOWING REQUIREMENTS AT THE TIME OF FILLING THE POOL:
If the water does not meet the established standards (not clean enough), you can use for cleaning of
water the filter bag, which is included in the complete set of filtration unit. To do this, insert the hose into
the filter membrane fix the membrane on the hose and start to fill the pool.
At the end of the swimming pool filling, rinse the membrane by water under pressure.
ADJUSTING THE DEVICE OF AUTOMATIC WATER ADDING
To keep water in the pool always at one level (1 cm
below the top of skimmer) necessary to adjust the screw
of automatic water adding in filtration compartment.
INITIAL START-UP
Following the instructions from Section 4, "Safety and warnings", do the electrical connections.
To remove air from the piping and pump, connect to the water supply flexible hose.
WARNING
Do not put the flexible hose in the discharge nozzle. Enough to keep the hose near the
discharge nozzle. Stop filling pipelines by water when the air bubbles will stop. After filling the pipeline,
make sure, that no leaks in the joints of pipes. Then fill the sand around the technical part and pipeline.
Insert the filter membrane inside of filtration unit (see Section 7 "Filtration membrane). Turn on filter
equipment and start primary cleaning of water in a manual mode. To do this, set the switch on the
electrical control panel in "manual ".
After two or three days of filtration unit in a manual mode, turn the switch on the electrical control panel
in "automatic mode" and Install on a timer duration cycles of water filtration.
TIMER SETTING
You can use the timer of electrical control panel to set the daily filtration time of your pool.
REMEMBER,
the more often filtered swimming pool, the cheaper to maintain it! Adapt the time of
filtering to water temperature (time of filtering = temperature of water divided by 2). For example, if the
temperature of water in your swimming pool = 24°
С
, then 24:2=12 hours (time which filtration unit must
work).
To set filtration time, it is necessary carefully to pull out the segments. One segment corresponds to 30
minutes. To set timer’s clock, it is necessary to rotate dial face clockwise until a set time. It is forbidden
to rotate a dial face counter-clockwise, it can damage it.
