Or press the On/Off for less than 2 seconds, only the motor will turn
off, the display will remain lit for 15 seconds. After 15 seconds you
will still have 5 minutes to change the cutting length.
After 5 minutes, the trimmer turns itself off and the cutting guide
remains in the last position used.
If the foil shaver is attached to the trimmer, turn the trimmer off by
holding the On/Off button for more than 2 seconds
USING ThE COMB GUIDE
Your i-trim stubble
+ comes assembled with the motorised comb
guide already installed. The comb guide allows you to change the
cutting length of your trimmer with ease. You’ll need to experiment
to find your preferred length, but as a guide, 0.4mm will give you
ultra close short, shadow stubble effect, whilst 2mm will give you
a longer designer stubble look, 3.4mm will give you a longer, more
rugged look, 5mm will give you a short beard and 8mm+ will give
you a full bearded look.
IMPORTANT:
Always remove and attach the comb guide BEFORE
turning the trimmer on.
To remove the comb guide,
first adjust the cutting length on the
trimmer to the longest length setting (15mm). Switch the product
off and then pull the comb guide upwards to remove.
(NB – When using the trimmer without the comb guide attachment,
the cutting length will be below 0.4mm. The length setting shown
on the LCD display will no longer be relevant when the comb guide
is removed).
To attach the comb guide, line up the long sides of the comb guide
(arms) with the sides of the i-trim stubble
+. The teeth of the comb
guide should be facing forwards. Push the comb guide down onto
the trimmer until it ‘clicks’ into place. This should then secure the
comb guide into place.
