3
2.2 Installation with Multiple Telephone Devices
(Refer to Figure 2 below for the following instructions.)
1.
Locate a telephone jack with an electrical outlet nearby. The VRI400 should be placed on a
flat horizontal surface. The VRI400 should be located away from the immediate vicinity of
mechanical noises, i.e. oxygen generators, electrical equipment such as televisions and radios.
2.
Unplug the cord from the wall jack and plug it into the jack on the rear of the VRI400 marked
“PHONE.”
3.
Find the phone cord supplied with the VRI400. The connector on one end of the cord is
larger than the connector on the other end. Plug the larger connector into the jack on the rear
of the VRI400 marked “WALL.” Plug the smaller end into the telephone wall jack.
4.
Plug the power cube into the electrical outlet. Verify that the outlet is
NOT
controlled by a
light switch.
5.
Turn the Power Switch on that is located on the rear of the VRI400.
6.
Perform the Range Test as described in Section 9.4.2.
8.
Call the Response Center and provide the Care Assistant with your Responder Information
and to perform an initial Customer Test.
C a l l e r I D o r
A n s w e r i n g M a c h i n e
E l e c t r i c a l
Outlet
T e l e p h o n e
Wall
J a c k
PHONE
R e s c u e A l e r t
Power
C u b e
W A L L
Figure 2: Installation with Caller-ID or Telephone Answering Machine
VRI400
