6.5mm
Cut away the covering inside
before install the air scoop
6x40 nylon
bolt
ABS air scoop
CA
Sticker
Wing bolt block
Plastic air scoop
6x40 nylon bolt
(Ply wood)
Plastic mount nut
WING
12mm
15/32
1/4
Using the ABS air scoop as a template,
trace around the outside edge of the ABS
air-scoop and then remove it.
Using a sharp hobby knife, cut away the
covering inside the lines. Not to cut into
the wood.
Apply the ABS air scoop in place and
secure with CA glue.
Cut away only
the covering
both side
A B
A
A’
90
O
90
O
Cut away only
the covering
both side
Apply the epoxy
both side
1-Trial fit the horizontal stabilizer in place . Check the alignment
of the horizontal stabilizer. When you are satisfied with the
alignment, use a pencil to trace around the top and bottom
of the stabilizer where it meets the fuselage.
2-Remove the horizontal stabilizer from the fuselage. Using the
sharp hobby knife, carefully cut away the covering inside the
lines which were marked above.
3-Spread epoxy (30 minute) onto the top and
bottom of the horizontal stabilizer along the
area where the covering was removed and
to the fuselage where the horizontal stabilizer
mounts.
4-Install the horizontal stabilizer into the fuselage
and adust the alignment as described in steep 1
5-Wipe off any excess epoxy using a paper towel
and rubbing alcohol.
Allow the epoxy to cure before proceeding to next
step.
Securely glue together. If coming off during
flight, you lose control of your air plane!
B
B’
A = A’
B = B’
6x40mm nylon bolt
.........2
9- Air scoop / Olkuhlerattrappe
10- Air scoop / Olkuhlerattrappe
Bottom view /Ansicht von unten
Vergewissern Sie sich, sauber geklebt
zu haben. Andernfalls konnen Probleme
mit der Flugeigenschaft auftreten!
11- Horizontal stabilizer / Hohenruder