Elevator pushrod
Elevator pushrod
Rudder pushrod
Rudder servo
Elevator servo
Throttle servo
Throttle pushrod
22- Linkages / Ruderanlenkung
X
3mm set Screw
2 mm
Elevator pushrod
NOTE: Place of the servos may be change
depend of engine (Four-stoke or two-stroke
engine)
21- Servo installation
Receiver area
4-1/4”(107 mm)
Wing center section
DO NOT try to fly an out-of-balance model !
1.4”(35) mm
1/4” (6mm)
25/64”(10mm)
1/4” (6mm)
25/64”(10mm)
1.4”(35) mm
24- Balance / Schwerpunkt
Note: Adjust the location of the
battery pack to achieve this C.G
location.
(A + or - 5mm is fine)
Bottom view /Ansicht von unten
Connector
Connector
............1
............3
Gestangeanschluss
Gestangeanschluss
Rudergestange
Rudergestange
Drosselservo
Seitenruderservo
Hohenruderservo
Rudergestange
25- Control surface
Ruderausschlage
RUDDER / SEITENRUDER
AILERON / QUERRUDER
IMPORTANT: Flying your model at these throws will provide you with the greatest chance for successful first flights. If,after you have
become accustomed to the way the Mig-3 flies, you would like to change the throws to suit your taste that is fine. However, too much
control throw could make the model difficult to control, so remember, “more is not always better”.
ELEVATOR / HOHENRUDER