Two pattern tours styles can be used:
A .
To-and-from scanning
1-2-…………..-16-1-2-……….-16-1-……….. Make an auto circle scanning by points.
Press EXIT key and exit to default status of the keyboard.
Input cruise No adjust key SCAM into to-and-from scanning
B.
Cruise scanning
1-2-………-15-16-15-………-2-1-2-……..-15-16-15-…Make an auto cruise scanning
Press EXIT key and exit to default status of the keyboard. Then input cruise group No and
then input Shift + Scan to put system into cruise scanning.
4.3 Auto Scanning (2points scanning,360
°
scanning)
The operator can also run a simple point-to-point scan (also called back-and-forth scanning). To do this,
set Preset Point A first (at the same time set the dwell time at Point A), and then set Present Point B (at
the same time set the dwell time at Point). Finally execute an outer command to scan between points A
and B.
4.3.1 2 Points Scan
1. To set Point A. Move the joystick to the desired position.
2. In the Main Menu enter a dwell time for Point A. Example: If Dwell time is 2 seconds the VKB300/200
keyboard displays:
3. Press PAN A.
4. To set Point B. Move the joystick to the desired position.
5. In the Main Menu enter a Dwell time for Point B.
6. Input the grade Speed (1-64) and Press AUTO
Example: Set dwell time of Point A as 2 seconds, dwell time of Point B as 3 seconds. Make the scanning
at 32-grade speed between the two points
a) Move control joystick to Point A of scanning
b) Input 02, then press Pan-A on the keyboard after two seconds
c) Move control joystick to Point B of scanning
d) Input 03, then press Pan-B on the keyboard after two seconds
e) Input 32 grade, then press AUTO key.
This will scan starting at Point A to Point B at a scanning rate of 32 grade stopping at Point A for 2
seconds and Point B for 3 seconds.
4.3.2 360° Scan
The Operator can also start an auto cruise scan. This scan will rotate 360° from the desired position.
15
Summary of Contents for VPTZ500
Page 3: ...2...
