VPG VanWeigh, Installation, Setup And Calibration Manual

Page: 30 / 82

30
1. Build the air pressure transducer:
i.
Disconnect the fitting from the sensor
cable
ii. Place the washer over the thread. It is
recommended that PTFE tape is also
applied
iii.
Connect the sensor to the fitting. Use
18 mm and 24 mm spanners to tighten
iv. Remove the cap from the sensor
v.
Connect the fitting and sensor to the
stem of the air pressure T-connector.
Push-fit until you hear two clicks to lock
the sensor and T-connector together
vi.
Connect the air pipe fittings to each
side of the tee on the T-connector.
Push-fit until you hear two clicks to lock
the air pipe fitting and T-connector together
ii iv
v vi
VanWeigh
®