3
Installation
MultiAP 700G acts as a bridge between the wireless and the wired Ethernet interface. A typical setup is
as follows:
3.1 Installation Procedures
1.
Attach the antenna to the MultiAP 700G unit.
2.
Connect the LAN port on the unit with the backbone network using an Ethernet cable. The port
could auto sense the cable is straight-through or cross-over.
3.
Connect the power adapter to the power connector of the unit, and then plug in the power
adapter.
4.
Wait for the status LED to turn green.
5.
Connect a PC to the backbone network, and configure the IP address of the PC to be any IP
address between
192.168.0.4
and
192.168.0.254
, with subnet mask of
255.255.255.0
.
6.
With Microsoft Internet Explorer 6 or above, or Mozilla Firefox 2.0 or above, connect to the URL
https://192.168.0.3
.
7.
When prompted, enter the default admin login ID and password:
admin
and
public
respectively.
This default username and password can be changed in the web admin. Please refer to section
5.6.2 for details.
8.
After logging in, the following Main Menu page appears to facilitate further configuration of the
