27
Trouble shooting
Q：
What if the files on the TF card cannot be identified?
A：
1. Clean and wipe the storage card
2. Format the storage card
3. Replace the storage card
Q：
What if the offset occurs on the finished model?
A：
1. Check the tightness of the synchronous belt and ensure it is correctly installed.
2. Slice the model again
3. Reduce print speed or adjust the acceleration value;
4. Make sure operating temperature doesn't exceed its assigned set-point
temperature 30℃.
Q：
What if the files are garbled and cannot be read?
A：
1. Change file name to English or numeric formats;
2. Format of your sliced files is not compatible;
3. Repair the model before slicing.
Q：
What if the noise occurs for the return to zero device?
A：
1. Check the return to zero sensor to see whether it has been knocked;
2. Check the lines and see whether the noises could stop if the sensor is pressed
by hand;
3. Take the replacement method to check.
Q：
Damage occurs when turn on the 3D printer.
A：
It might be caused by dialing error from switch power supply, please check
whether the voltage is set to the correct value. If the voltage is 110V and the
power supply is 220V, damage will occur. Please select 110V/230V by switch
before power on.
Q：
Unable to resume printing from power failure?
A：
It might be caused by different TF card. Make sure you are using the same TF card
before and after the power cut off.
Q：
Too much filament oozing?
A：
1. Reduce print temperature by 5~10℃;
2. Increase traveling speed, or increase the retraction length and speed.
Q：
No filament coming out during printing?
A：
1. The arm force of the feeding structure might be too tight to allow the filament
out. Please adjust the arm force, neither too loose nor too tight.
2. Lower the retraction length to avoid any abrasion.
3. Check whether the extruder is clogged, clean it with the needle if
necessary.
Summary of Contents for Aquila X2
Page 31: ......
