Wire connection
9
Insert the teflon tube into the pneumatic connector
Attention
· Damage might occur if voltage setting
is incorrect. Make sure the current input
voltage matches to your local power
supply
(115/230V)
.
· Plug in power cord and turn power
switch to 1 to turn it on.
· Do not disconnect the cables when the
printer is powered on.
1. Insert the teflon tube into the pneumatic connector.
2. Connect the yellow-labeled cable on 6 pin (4 wires) port to E-axis stepper motor.
3. Connect the yellow-labeled cable on 6 pin (4 wires) port to X-axis stepper motor.
4. Connect the yellow-labeled cable on 3 pin (2wires) port to X-axis limit switch.
5. Connect the cable on 3 pin port to filament detector.
6. Connect the yellow-labeled cable on 3 pin port to Z-axis limit switch.
7. Connect the yellow-labeled cable on 6 pin port to Z-axis motor.
8. Plug in the power cord (as showed) and toggle the switch to turn on the power.
X、E、Z-axis motor port
X、Z-axis limit switch
Power cable *1
！
X motor
X-axis limit switch
Z-axis limit switch
E motor
Filament detector
Z motor
16
2
5
4
3
1
6
7
8
Summary of Contents for Aquila X2
Page 31: ......
