--11--
Declaration of Conformity:
In accordance with the provisions of Directives 2014/35/EU, 2014/30/EU, 2009/19/EC, this
product complies with the following standards or normative documents:
EN55014-1; EN55022 B; EN61000-6-1; EN61000-4-2; EN61000-4-3; EN61000-4-4;
EN62368-1; EN50498.
Disposal of the
product in the
household
waste is not
allowed.
The product conforms to RoHS.
It complies with the directive
2011/65/EU for Reduction of
Hazardous Substances in electrical
and electronic equipment.
Safety Regulations and Appropriate Application:
The charging converter has been designed according to the valid safety regulations.
Appropriate application is restricted to:
1.
Charging of lead-gel, lead-AGM, lead-acid or LiFePO4 complete batteries (with integrated BMS, balancing,
safety circuit and approval!) Charging of batteries of the indicated nominal voltage and simultaneous supply
of the consumers being connected to these batteries in fixed installed systems with the indicated battery
capacities and charging programs.
2.
Simultaneous supply of consumers being connected to these batteries in fixed installed systems.
3.
Connection in consideration of the indicated cable cross-sections at the inputs and outputs of the unit.
4.
Connection in consideration of the indicated battery capacities at the inputs and outputs of the unit.
5.
Fuses of the indicated capacity are to be provided near the battery to protect the cabling of the batteries.
6.
Technically faultless condition.
7.
Installation in a well-ventilated room, protected from rain, humidity, dust, aggressive battery gases, as well as
in an environment being free from condensation water.
Never use the unit in locations where the risk of gas or dust explosion exists!
Open-air operation of the unit is not allowed.
Lay the cables in a way, that damages are excluded and observe to fasten them tightly.
Never lay 12 V cables and 230 V mains supply cables into the same cable conduit (empty conduit).
Check live cables or leads periodically for insulation faults, points of break or loosened connections. Occurring
defects must be remedied immediately.
The unit is to be disconnected from any connection prior to execution of electrically welding or work on the
electric system.
If the non-commercial user is not able to recognize the characteristic values being valid for a unit or the
regulations to be observed, expert advice is to be obtained.
The user / buyer is responsible for the observation of construction and safety regulations of any kind.
The unit does not contain any parts, which can be replaced by the user
.
Even after having been switched-off,
the unit may be live for an extended period (particularly in case of failure).
Keep children away from the unit and the batteries.
Observe the safety regulations of the battery manufacturer; deaerate the battery room, if required.
Non-observance may result in injury or material damage.
The warranty period is 36 months from the purchase date (against presentation of the sales slip or invoice).
The warranty will be void in case of any inappropriate utilisation of the unit, if it is used beyond the technical
specification, in case of improper operation or external intervention. We do not assume any liability for any
damage resulting hereof. The liability exclusion is extended to any service being executed by third, which has not
been ordered by us in writing. Service is to be effected exclusively by VOTRONIC Lauterbach.
