Vortice LINEO 250 QUIET ES, Instruction Booklet

Page: 14 / 92

Selecting the operating mode
Setting the V1 and V2 values
The appliance leaves the factory with default nominal settings V1=VMIN, V2=VMAX
Values V1 and V2 can be adjusted as follows:
Two-speed mode:
cut off the power supply
set the dip-switch SW2 indicated in the figure:
Int.2=ON; Int.3=OFF; Int.4=OFF
ON
1 2 3 4
OFF
Adjustable speed mode:
cut off the power supply
set the dip-switch SW2 indicated in the figure:
Int.2=OFF; Int.3=OFF; Int.4=OFF
ON
1 2 3 4
OFF
14
ENGLISH
Isolate the power
To set the trickle and boost variable speeds.
Set the SW2 dip-switch as follows:
1 to off, 2 to off, 3 to off, & 4 to on
ON
1 2 3 4
OFF
When the power is switched on, the trickle speed (V1) runs at the fac-
tory default speed.
The trickle / default speed (V1) can be adjusted to the desired flow
rate using the potentiometer.
A small flat head screw driver will be required.
The trickle (V1) speed should set 100 rpm lower than the desired
boost (V2)
The trickle speed value can now be saved by switching 1 to on.
The boost (V2 default) can now be adjusted
using the potentiometer.
ON
1 2 3 4
OFF
Once the desire boost flow rate is achieved it can be set
by switching 1 to off.
ON
1 2 3 4
OFF
Isolate the power
To complete the commissioning and prevent tampering
set 1, 2, 3 & 4 to off
ON
1 2 3 4
OFF