Typical applications
LINEO 250 ES / LINEO 315 ES: fig. 1-2
Installation
Fig. 3 ÷ 25.
Fig.3: B= Air flow direction data plate; C= Inlet; D= Outlet.
Wiring diagram
LINEO 250 ES:
Fig. 16 ÷ 20
LINEO 315 ES:
Fig. 21 ÷ 25.
Initial configuration
The installer must configure appliance operation by following the steps described later on.
Selecting the product model: see below. This step is carried out in the factory; the instructions provided in this
booklet may only be of use if it becomes necessary to reset the status following accidental tampering with the
dip-switch.
Selecting the operating mode: see below. There are two modes: with two speeds V1 and V2, which can be
selected via an external switch, or with speed that can be adjusted via an external potentiometer.
Setting the V1 and V2 values (for two-speed operating mode)
Selecting the product model
The model is selected by setting the dip-switch 1 indicated in the figure as described in the table below.
13
ENGLISH
ON
1 2 3 4
OFF
DIPSWITCH
TRIMMER
1
2
SW 1
: MODEL
SW 2
: SETUP
LINEO 250 ES
LINEO 315 ES
Model
SW1
Int. 1
Int. 2
Int. 3
Int. 4
LINEO 250 ES
OFF
ON
ON
OFF
LINEO 315 ES
OFF
ON
ON
ON
Summary of Contents for LINEO 250 ES
Page 68: ...68 1 2 4 5 6 ...
Page 70: ...70 2 1 A 10 11 ...
Page 72: ...72 1 2 3 10A 11A ...
Page 73: ...73 12 15 Ø14 mm Ø16 mm 13 LINEO 315 ES L N LINEO 250 ES 14 14A ...
