13
12
RANGING IN NORMAL MODE
With the Razor
®
HD 4000 powered up,
position the reticle on the target object
and press and release the Measure
button to get the distance measurement.
If the laser is not able to range due to
the reflectivity of the target, you will see
a display similar to that shown here. To
range a new target, simply re-aim and
press the Measure button again.
SCAN RANGING
Activate Scan Ranging by pressing
and holding the Measure button down.
Keeping the button depressed will
continuously measure distance as you
pan back and forth across target objects.
Scan will blink as you pan. Releasing the
Measure button will return laser to the
Power Up condition.
Note: For best results, it is recommended
to use a tripod while attempting to range
targets past 1,000 yards.
No Range
Returned
HCD Scan
LOS Scan
SETTING AND USING TARGET MODES
While in ready condition, cycle between target modes by
pressing and releasing the Menu button. Once a target
mode is selected, press the Measure button to activate the
target mode. Continue to hold the Measure button while
ranging in First, Last or ELR target mode.
For First and Last Mode, “First” and “Last” will flash while
the Measure button is being held signaling that you are in the
respective target mode. The range measurement will display
as the Measure button is held. After 10 seconds of holding
the Measure button, you will need to release and re-press and
hold the Measure button to reactivate the target mode.
For the Extended Laser Range Mode (ELR), “ELR” will flash
while the Measure button is being held signaling that the
rangefinder is acquiring the range of the target. The flashing
will stop once the range is acquired and remain displayed
for ~20 seconds after the Measure button is released.
Note: While using ELR mode, it may take up to 20 seconds
to acquire a target depending on the size of the target,
distance to the target, reflectivity of the target and the
environmental conditions.
