![background image](http://html1.mh-extra.com/html/vortex-rc/vt-allrounder/vt-allrounder_instructional-manual_1050678003.webp)
What's in the kit.
o
1 Nos. Laser Cut Coro Sheet (A, B, C and D )
o 1 Nos. CNC cut Left Wing Airfoil Foam Panel in its
wing bed
o 1 Nos. CNC cut Right Wing Airfoil Foam Panel in its
wing bed
o 2 Nos CNC cut Foam wing adapters
o 2 Nos. Aluminium round spars ( For Expert Wing, 3 Pcs )
o 1 Nos. CA Adhesive
o 1 Nos. 5 minute Epoxy
o 2 Nos. Lamination sheets
o 1 Nos. Fiberglass adhesive sheet
o Control Horns ( 2 Nos. Trainer. 4 Nos. Intermediate and Expert )
o Clevis ( 4 Nos. Trainer. 8 Nos. Intermediate and Expert )
o Pushrods ( 2 Nos Trainer. 4 Nos. Intermediate and Expert )
o 4 Nos. Rubber Bands
o 3 Nos. Laser Cut Dihedral Brace
(Not included/required in Expert Wing)
o 2 Nos Wooden Spar Joiner Dowels
( Only for Expert Wing )
o 1 Nos Laser Cut Motor mount
o 2 Nos. Aluminium Wing Holding rods
o 1 Nos Battery Strap
o 1 Nos Pin and thread
o 4 Nos Machine Screws
o Velcro Hook and Loop Material
o 1 Nos. 320 Grit Sand Paper
o 1 nos. Hobby Knife
o 2 Nos. Decal Sheets
Electronics Package (Optional) includes:
o
9 gm Servos ( 2 Nos. for Trainer, 3 Nos for Intermediate
and 4 Nos for Expert )
o 1 Nos. 18Amp Brushless ESC ( Speed controller )
o 1 Nos 2822 1200KV Brushless Motor
o 3 Pair 3.5mm Bullet connector
o 1 XT60 Male Connector
o 1 Nos
Balanced
Propellor 9x4.7
o 15cm Servo Extension wire ( 1 Nos. Trainer. 2 Nos
Intermediate and 4 Nos. Expert )
o 1 Nos Servo Y Cable (Only for Expert Wing)
o 1 Nos Prop Saver with Rubber Bands
o 8 Pcs Heat Shrink Tube Red and Black
www.Vortex-RC.com
3
Summary of Contents for VT-AllRounder
Page 35: ...www Vortex RC com 35 ...