Step 3. Prepare/Hinge the Tail surfaces.
30 mins
Prepare the Elevator by drawing a line
3cm from the trailing edge
. You may
adjust the line so it comes in
between two flutes, which will
enable cutting . Refer to the
hinging technique explained
earlier in the manual. Use the
knife to cut out
only one side
of
the coro material. The idea is to
create a hinge by cutting only one side of coroplast.
Flex the joint to one side, and clear out the protruding coroplast material carefully. Add packing tape
to the joint to reinforce. Test the elevator by moving it to both sides. It should be free to move.
Likewise prepare the rudder by scoring a line
3.5 cm
from the aft line
. Follow the same technique as with the
elevator to create the Rudder hinge.
www.Vortex-RC.com
10
Summary of Contents for VT-AllRounder
Page 35: ...www Vortex RC com 35 ...
