F. Join the panels
For Intermediate/Trainer Wings : use the Laser Cut dihedral brace.
Lightly sand the root sides of the wings to ensure they fit properly. When satisfied, cut the
slots for the dihedral braces, and test fit in place. The two thicker braces go in the front , and
the thin one goes near the trailing edge. One of the thicker braces can go forward of the spar,
and the other can go behind the the spar. Place the left wing on its bed, and prop up the
other wing tip to set the correct dihedral angle (
For Trainer Wing: 20Cm. For Intermediate
Wing : 9 Cm
) use epoxy to glue the panels and the dihedral in place. Double check this very
carefully before gluing.After glueing, inspect the joint carefully, and apply some packing tape
to the joint to ensure it doesn’t move while the epoxy cures. Be sure to keep one wing panel
propped up.
www.Vortex-RC.com
24
Summary of Contents for VT-AllRounder
Page 35: ...www Vortex RC com 35 ...
