VorTek SonoPro Professional S36 Series, Instruction Manual

Page: 45 / 108

Series S36 Instruction Manual Chapter 3 Operation
3-6 800120
Example for Setting an Output
The following shows how to set Output 1 to measure mass flow with 4 mA = 0 lb/hr and 20 mA = 100 lb/hr
with a time constant of 5 seconds. Note: all outputs are disabled while using the Setup Menus.
First, set the desired units of measurement:
1. Use

keys to move to the Units Menu (see page 3-13).
2. Press  key until Mass Flow Unit appears. Press
ENTER
.
3. Press  key until lb appears in the numerator. Press  key to move the underline cursor to the
denominator. Press the  key until hr appears in the denominator. Press
ENTER
to select.
4. Press  key until Units Menu appears.
Second, set the analog output:
1. Use  keys to move to the Output Menu.
2. Press the  key until 4-20 mA Output 1 appears.
3. Press  key to access Measure selections. Press
ENTER
and press the  key to select Mass. Press
ENTER
.
4. Press  key to set the 4 mA point in the units you have selected for mass of lb/hr. Press
ENTER
and
use  keys to set 0 or 0.0. Press
ENTER
.
5. Press  key to set the 20 mA point. Press
ENTER
and use  keys to set 100 or 100.0. Press
ENTER
.
6. Press  key to select the Time Constant. Press
ENTER
and use  keys to select 5. Press
ENTER
.
7. Press the
EXIT
key and then
ENTER
to save changes and return to the Run Mode screen..