VONETS
450M 5G+300M 2.4G
High Power WiFi bridge, repeater
12
affect the WiFi connection performance, or even damage the device,
so we suggest high quality power supply, recommand the total input power is
5V/3A(15W), Ripple less than 100mV power supply.
For module, please
make sure use
dual power supply (5V/1A, 5V/2A)
according to PIN
definition.
5. The device has been configured the source WiFi hot spot parameters, the smart
phone or PC has connected to the device WiFi hot spot, but still doesn’t get internet?
First, check the status light to know the current state of the device, then according
to the state of the device to analyze the fault reasons;
Reason 1. The distance between the device and source WiFi hot spot is too long,
cause the communication performance degradation, finally effect the user’s access
to the Internet. At this time, just need shorten the distance between the device
and source WiFi hot spot to solve this problem;
Reason 2. Due to some unexpected operation or power down, caused the destroy
of device parameters. At this time, just need to reset the device to factory default
parameters;
Reason 3. The configured source WiFi hot spot parameters are not correct. At this
time, just need to configure the correct parameters then reboot the device;
6. The smart phone or PC has been connected the device by WiFi or Ethernet cable,
but user can’t log in the device WEB page, or after log in the WEB it shows error?
Reason 1. The users don
’
t use the browser recommended by VONETS(IE, Google
Chrome, Safari, the mobile phone browser);
Reason 2. The smart phone or PC installed the firewall, the security level is set too
high, caused the above problem. At this time, only need to close the firewall;
Reason 3. The security level of browser is too high, it will also cause the above
problem. At this time, just need to reduce the browser
’
s security level, then log
in again;
Reason 4. The IP address of the device input error. For devices that are in use,
the IP address of the device is automatically assigned by the source hot spot, so
the IP address will change, at the same time, you can review “
Note 1
” to obtain IP
address; for the new factory equipment, users only need to enter the correct
default IP, VGA series default IP is 101.12.30.56, PM5G / PM2.4G the default IP is
192.168.254.254.
Shenzhen Houtian Network Communication Technology Co.,Ltd
http://www.vonets.com
