VONETS
450M 5G+300M 2.4G
High Power WiFi bridge, repeater
11
VGA1000/VGA2000 Indicator Light Instruction
WiFi Status Light
Hot spot connection Status
Remark
(Green light) Quick Flash
Not connected
Products are not connected to
any hot spots
(Green Light) Quick Flash
Connected
WiFi hot spot signal >50%
(Green Light)
Intermittent Quick Flash
Connected
WiFi hot spot signal is 10%-50%
(Green Light) Slow Flash
Connected
10%WiFi hot spot signal is less
than 10%
(Green Light) Slow Flash
Connection failed
Products are not connected to
any hot spots
General operation and common faults of
VGA/PM5G/PM2.4G Series Products
1. How to reset to the factory default parameters of VGA?
Power on the device, after 50 seconds, f
irst, make the device boot normally; long press
3 seconds until the indicator light flash, after flashing, quick press twice, the battery
indicator flashes in a flowing state, it will take about 85 seconds.
During the recovery of the factory operation, the product can’t be powered off,
otherwise it may cause damage to the product.
2. How to reset the factory default parameters of PM5G/PM2.4G?
Power on the device, after 50 seconds, long press reset button (or connect Reset PIN
of module to GND) 3 seconds, then release, module will factory reset, it will take 85
seconds, during the recovery of the factory operation, the product can’t be powered off,
otherwise it may cause damage to the product.
3. Does the VONETS series product support firmware upgrade, how to upgrade?
All VONETS series products support firmware upgrade, and support online upgrade,
please visit website:
www.vonets.com
to refer to the related documents.
4. The WiFi hot spot of VGA/PM5G/PM2.4G can be found, but the smart phone or PC
can’t connect to this device hot spot?
Reason 1. Due to some unexpected operation or power down, caused the
destroy of device parameters. At this time, just need to reset the device to
factory default parameters;
Reason 2.
Poor power supply performance of the device will seriously
