communication
–
simple
–
flexible
–
unlimited
© Vonamic GmbH 2021
Subject to technical modifications
5
Step 1:
Type “network and sharing“
into the
Search box
in the
Start Menu
Step 2:
Select
Network and Sharing Center
Step 3:
Click on
Change adapter settings
on the left of PC screen
Note:
Users can also skip step 1 to 3, by pressing
R
and type ”ncpa.cpl” command
to get to step 4 directly.
Step 4:
Right-click on your local adapter and select
Properties
Step 5:
In the
Local Area Connection Properties
window highlight
Internet
Protocol Version
4 (TCP/IPv4)
then click the Properties button.
Note:
Be sure to record all your PC’s current IP settings to be able to restore them later.
Step 6:
Select the radio button
Use the following IP address
and enter in the IP for the PC (e.g.
any IP address not in use, and in between 192.168.100.1 and 192.168.100.254), Subnet
mask (e.g. 255.255.255.0), and Default gateway that corresponds with your network
setup. Then enter your preferred and Alternate DNS server addresses.
Step 7:
Click
OK
to change the PC’s IP address.
3.
Turn on the switch that will be used for configuration and as the voltage source of the V910. Wait
until the start-up process is completed.
4.
Make sure that PoE is activated on the switch. Connect the V910 to an PoE Port using a standard
network cable, and check the port LED on the switch to make sure the link status of the V910 is
OK.
5.
Connect the PC to any port on the switch using a standard Ethernet cable, and check the port LED
on the switch to make sure the link status of the PC is OK.
6.
Run your Web browser on the PC; enter the factory default IP address, to access the V910 Web
interface.
If your PC is configured correctly, you will see the login page of V910 as shown below.
If you do not see the above login page, please perform the following steps:
-
Refresh the web page.
-
Check to see if there is an IP conflict issue.
-
Clean browser cookies and temporary internet files.
-
Check your PC settings again and repeat step 2.
