Volvo V60 Twin Engine, Owner'S Manual

Page: 350 / 440

||
WHEELS AND TYRES
348
15. As soon as possible, drive at least 3 km at a
maximum speed of 80 km/h (50 mph) so
that the sealing fluid can seal the tyre.
NOTE
Sealant will spurt out of the puncture during
the first few rotations of the tyre.
WARNING
Make sure that nobody is standing near the
car and gets the sealing fluid splashed onto
them when the car is driven away. The dis-
tance should be at least two metres.
16. Follow-up inspection:
Connect the air hose on the tyre's air valve
again and check the tyre pressure with the
pressure gauge, see Emergency puncture
repair - rechecking (p. 348).
Related information
•
Emergency puncture repair (p. 344)
•
Emergency puncture repair - rechecking
(p. 348)
•
Emergency puncture repair kit - overview
(p. 345)
Emergency puncture repair -
rechecking
When a tyre has been sealed with the emer-
gency puncture repair kit, Temporary Mobility Kit
(TMK), a subsequent check must be made after
approx. 3 kilometres of driving.
Check tyre pressure
Take out the tyre sealing equipment. The com-
pressor must be switched off.
1. Remove the valve cover, see (p. 347).
Unscrew the tyre's dust cap.
Take out the air hose and screw in the
valve connection to the bottom of the thread
on the tyre's air valve.
2. Read the tyre pressure on the pressure
gauge.
•
If the tyre pressure is below 1.3 bar
28
then the tyre is insufficiently sealed. The
journey should not be continued. Contact
a tyre centre.
•
If the tyre pressure is higher than 1.3
bar
28
, the tyre must be inflated to the
pressure specified in accordance with the
tyre pressure table, see Tyres - approved
tyre pressures (p. 423).
•
Release air using the pressure reducing
valve if the tyre pressure is too high.
3. If the tyre needs to be inflated:
1. Plug the electrical cable into the closest
12 V socket and start the car.
2. Start the compressor and inflate the tyre
to the pressure specified in accordance
with the tyre pressure table.
3. Switch off the compressor.
28 1 bar = 100 kPa.