Volvo S 60, Owner'S Manual

Page: 81 / 452

INSTRUMENTS AND CONTROLS
}}
* Option/accessory, for more information, see Introduction. 79
Key positions
The remote control key can be used to set the
vehicle's electrical system in different modes/
levels so that different functions are available;
see Key positions - functions at different levels
(p. 79).
Ignition switch with remote control key extracted/
inserted.
NOTE
For cars with the keyless start and lock sys-
tem
*
the remote control key does not need to
be inserted into the ignition switch but can be
stored in e.g. a pocket. For more information
on the keyless start and lock system, see
Keyless drive
*
(p. 167).
Insert the remote control key
1. Hold the end of the remote control key with
the detachable key blade and insert the
remote control key in the ignition switch.
2. Then press the remote control key in the
ignition switch up to its end position.
IMPORTANT
Foreign objects in the ignition switch can
impair the function or destroy the lock.
Do not press in the remote control key incor-
rectly turned - hold the end with the detacha-
ble key blade, see Detachable key blade -
detaching/attaching (p. 163).
Remove the remote control key
Grip the remote control key and pull it out from
the ignition switch.
Key positions - functions at different
levels
To enable the use of a limited number of func-
tions with the engine switched off, the car's elec-
trical system can be set in 3 different levels -
0
,
I
and
II
- with the remote control key. This owner's
manual describes these levels throughout using
the denomination "key positions".
The following table shows the functions available
in each key position/level.