Fit protecting plates over the bolt heads.
22. Fit the half shafts in the axle housing.
23. Fit brake discs and O-rings on the axle housing.
24.
Figure 6
Fitting hub retainer
25. Fit the hub retainers.
Tighten the bolts to 310 N m (229 lbf ft).
26. Rotate the pinion shaft and place the differential lock drive flange in maximum engagement by screwing the
diaphragm sleeve counter-clockwise until the differential lock drive flange is in maximum engagement, see
.
Figure 7
Check by rotating one of the front wheels of the machine forward and backward.
27. Then screw the sleeve clockwise four turns so that the differential lock becomes disengaged.
Lock the pushrod with the stop screw.
Tighten the stop screw to 30 N m (22 lbf ft).
28.
Figure 7
Adjusting differential lock
1
Hook spanner
29. Fit support washer, diaphragm and thrust washe.
Bolt on the cove.
NOTE!
The convex side of the support washer should be turned toward the diaphragm and the cover filter turned
downward, see [Invalid linktarget] item 16.
30. Connect electrical leads and hoses to differential lock and brake. Clamp the leads and hoses.
31.
