29. Place the ring gear hub in position, see
and fit the hub nut while the lifting device is holding the hub at
Figure 9
right angles to the axle.
30. Tighten up the bearings with the aid of the hub nut until a bearing clearance of 0.3 - 0.5 mm (0.012 - 0.020 in) is
obtained. Rotate the hub at least five turns.
31. First measure the rolling resistance and then increase the measured spring balance force by tightening up the hub
nut. See specifications page 0:8.
NOTE!
For run-in bearings the measured force should be increased less, see specifications page 0:8.
32.
Figure 10
1
Spring balance
2
E765 rear axle or E1109 front axle
33. Lock the hub nut with lock washer and lock ring, see
.
Figure 11
NOTE!
The washer can be fitted in two ways in order to double the locking possibilities. The washer is also available in two
versions.
NOTE!
On the front axle the hub nut is secured with lock screws. Use locking fluid medium on these screws.
34.
Figure 11
1
Lock washer
2
Lock ring
35. Make sure that the thrust washer is in place and fit the sun gear and the planetary retaine.
NOTE!
Make sure that the oil draining hole aligns with the outlet in the hub, see
. Use sealing compound
Figure 2
(silicone).
Tighten the bolts to 180 N m (133 lbf ft) rear axle 160 N m (118 lbf ft) front axle.
