26
D7600309
Tighten the retaining nut. Tighten to 70 Nm (52.5 lbf. ft). Use
socket (P/N 9995469) and a Torx socket as a counterhold.
27
M7600373
Install:
the upper bearing (1)
the washer (2)
a new nut (3). Tighten the nut to 70 Nm (52.5 lbf.ft). Use socket
(P/N 9995467) and a Torx socket as a counterhold
the cover.
Remove the spring tools by slackening them off alternately.
28
Install the spring strut on the car body. Use the new nuts and
washers from the kit according to point
Tighten the three nuts for the spring strut bearing. Tighten to
25 Nm (18.5 lbf. ft.).
29
Install the spring strut on the stub axle. Use new screws and
nuts from the kit
Adjust to the value measured previously at (A) according to point
, to obtain the correct camber angle
Tighten to 105 Nm (78.5 lbf.ft.) Angle-tighten to 90°. Use the
protractor (P/N 9512050)
Reinstall the bracket for the ABS sensor cable. See point
Reinstall the ABS sensor cable in its bracket.
Installation instructions, accessories
Volvo Car Corporation Gothenburg, Sweden
© Volvo Car Corporation
Lowered sports chassis- 8670993 - V1.0
Page 17 / 18