Volvo Penta TAMD63L, Instruction Book

Page: 38 / 124

1) 2)
*
3) 4)
* *
Maintenance schedule
The description applies generally for all engines unless otherwise stated.
If longer intervals are required than those stated below the oil’s condition must be tested
regularly by the oil manufacturer.
The time intervals are guides which apply to normal operating conditions. For new or
reconditioned engines see under the heading. “Running-in” on page 4.
All operations below with the exception of points 17, 21 and 32 must be carried out at least
once per year even if the operating time in the schedule has not been reached. Operations
17, 21 and 32 must be carried out at least once every other year.
NOTE! Always turn the engine off before starting service procedures (except opera-
tion 16)!
1. Changing the Engine oil.
Note. Refer to table on page 35 for infor-
mation on oil grade/intervals between
changes.
1) For TAMD63, TAMD73 and TAMD74.
2) For TAMD71 engines.
2. Replace oil filter (1) and
by-pass filter if fitted (2)
at every other oil change.
3. Change oil in reverse
gear.
3) MPM (ZF).
4) Twin Disc.
4. MPM reverse gear:
Remove and clean re-
verse gear oil screen.
5. Replace oil filter on MPM
IRM 301A and 302V re-
verse gears.
* Note. Special recommendations apply for new or reconditioned
engines. See instructions “Running-in” on page 4.
49
49
50
50
–
Engine oil VDS or CD or CE as per API system. Drain or pump out oil while engine
is hot.
Warning! Hot oil can cause burns.
Remove plug and oil screen. Clean screen and reinstall components removed.
Start engine (after filling with oil) and check for leaks.
Lubricate gasket and screw on new filter by hand. Tighten by 3/4 turn once gasket
is tight. Top up with oil. Start engine, check for leaks. Check oil level (point 3
above).
50 Hrs 100 Hrs 250 Hrs 500 Hrs 1000 Hrs 2000 Hrs
No. Operation Instructions
Info.
pge.
TAMD63, TAMD73, TAMD74 TAMD71
Lubricate gasket and screw on new filter by hand. Tighten by 3/4 turn once
gasket is tight. Top up oil, start, check for leaks. Stop engine and check oil
level.
Fill up with oil. Quality: Use CD, CE or CC engine oil, but not multigrade oil. For
viscosity refer to Technical Data. Check the oil level. Note: The markings on the
dipstick refer to levels at operating temperature (with the engine idling and the
control in neutral).
7740156 - Downloaded from www.volvopenta.com 22/07/2009 00:44:08