Volvo Penta TAMD162C, Instruction Book

Page: 34 / 84

Set lever (2) towards the filter which is to be on-line, replace the other filter
as per instructions in operation 15. Vent by opening the venting screw (1).
Move lever (2) to vertical (on-line) position. Close the vent screw when no
more air bubbles are visible in the fuel. Repeat the procedure for both
filters.
Observe strict cleanliness! The fuel in the system must not become
contaminated.
50 hours 500 hours 1000 hours 2000 hours 24 months 50 hours 400 hours 800 hours 1200 hours 24 months
No. Action TAMD162C, TAMD163P Instructions
Info.
pages
11. Check/adjust disengagea-
ble clutch (if fitted).
12. Replace crankcase ventila-
tion filter.
Note. Replace the crankcase ventilation filters
earlier if air mixed with oil starts to escape via the
valve.
13. Check/drain extra fuel
filter.
14. Replace insert in extra fuel
pre-filter.
15. Replace fine fuel filters.
16. Engine fine fuel filters,
replacement while engine
is running.
Remove the filter by turning counterclockwise. Screw on the new filter by
hand.
Wait a few hours after the engine has been turned off before checking/
draining the filter.
Drain off water/contaminants through the cock/plug (1).
Adjustments must be made with the engine stopped.
Remove the inspection cover. Release the catch (A) and turn the adjust-
er ring (B) clockwise. Engage the catch. The clutch plates must not slip
after engagement.
Alternatively change at a vacuum of 16–20 in. HG measured at full RPM,
loaded engine, in the suction line between the filter and the feeder pump.
Remove the fuel filter using the special tool. Screw on the new filters by
hand. Then turn a further half turn when the rubber gasket on the filter
base in contact with the filter housing mounting. Vent fuel system.
Observe strict cleanliness! The fuel in the system must not become
contaminated.
TAMD163A
79
40
50
50
50
51