Volvo Penta TAMD162C, Instruction Book

Page: 33 / 84

Use CD, CE or CC engine oil, but not multigrade oil. For oil quality, see
“Technical Data”. Use the engine scavenging pump with hose to the re-
verse gear pipe for the dipstick. Or unsrew the drain plug. Check the oil
level with the dipstick. Note! The markings apply at operating temperature
(engine at idle and control in neutral position).
3– 4 pumps on each nipple.
Remove the oil filter using the special tool. Lubricate gasket and screw on
new filters by hand. Tighten a further 3/4 turn once gasket is in contact with
the mounting.
Remove and clean the oil screen. Check the gasket. Reinstall the parts
removed and check for leaks.
Use lithium-based lubricating grease: Mobilux EP2, Statoil Uniway EP2N,
Texaco Multifak EP2, Q8 Rembrandt EP2.
Do not lubricate support bearing (a grease nipple is fitted), main bearings,
disengaging shaft and moving parts of clutch mechanism.
Lubricate sparingly (20–30 g for main bearings). Quality: Use lithium-
based lubricating grease: Mobilux EP2, Statoil Uniway EP2N, Texaco
Multifak EP2, Q8 Rembrandt EP2.
50 hours 500 hours 1000 hours 2000 hours 24 months 50 hours 400 hours 800 hours 1200 hours 24 months
No. Action TAMD162C, TAMD163P Instructions
Info.
pages
5. Change oil in reverse gear.
6. Replace oil filter on MPM
IRM350 and Twin Disc
MG516 reverse gear.
7. Clean oil screen in reverse
gear.
8. Lubricate release bearing
on disengageable clutch.
Note. Every 50 hours if the clutch is used more
than 15 times per day. Otherwise every 500
hours.
9. Lubricate disengageable
clutch (if fitted).
10. Lubricate side mounted
power take-off.
TAMD163A
45
46
45
46
46
–