4
Install the pump rotor (
1
), end washer (
2
), shim
(
3
), spring (
4
) and bush (
5
) in the oil pump gear
wheel. Install the retainer ring (
6
) on the shaft.
NOTICE!
Note that the end washer (
2
) has a hole
(
7
) that must mate up with the guide pin in the
timing gear cover.
Install a new gasket on the timing cover.
NOTICE!
If the gasket has a center section (
8
),
this must be cut away.
5
Put the control rod (
1
) on the heel (
2
) in the timing
gear cover. Turn the stop arm (
3
) round so that
the control rod is held against the heel.
6
Install the timing gear cover at the same time as
the control rod (
1
) is held fast by the stop arm (
2
).
Put the timing gear cover in place. Make sure that
the control rod ends up in the correct position and
that the pin (
3
) engages in the hole (
4
) in the oil
pump end washer.
Bolt on the timing gear cover.
6
5
3
2
7
8
1
4
P0008047
1
2
3
P0008048
1
2
3
4
P0008049
21-5 Timing Gears and Shaft
47701798 05-2013 © AB VOLVO PENTA
81
Summary of Contents for D1-13
