VOLTCRAFT B6 Duo, Operating Instructions Manual

Page: 86 / 208

86
16. VARIOUS BASIC SETTINGS (“USER SET”)
• In the main menu, select the “USER” menu with the “TYPE/STOP” button.
• Press the button “ENTER/START”; the display shows the following, for example:
Here you can select one of the three lithium battery types the charger is able to work
with (“LiPo”, “LiIo”, “LiFe”).
• Briefly press the button “ENTER/START”. The voltage value then begins to flash.
With the buttons “INC” or “DEC”, you can select the cell voltage “3.3”, “3.6” or “3.7”. At
the same time, the corresponding battery type changes in the top line.
Confirm the selection of the lithium battery type with the button “ENTER/START”, and the
voltage value stops blinking.
¼
The settings made here for the lithium battery type then applies for ALL other
functions, e.g. charging, discharging, etc. (see chapter 11).
• With the button “INC”, switch to the next setting (or to the previous one with the button
“DEC”).
Here you can set the time in which the charger checks a connected lithium battery for
the correct cell count and terminates the charge process, if applicable.
This may be especially helpful with deep discharged batteries. For a battery with a
higher capacity set a longer time; for one with a lower capacity set a correspondingly
shorter time.
Briefly press the button “ENTER/START”. The time then begins to flash. With the buttons
“INC” or “DEC”, you can select the time (5 to 60 minutes). Save the setting with the
button “ENTER/START”; the time stops blinking.
USER SET USER SET
USER SET USER SET
USER SET
PROGRAM->
PROGRAM->
PROGRAM-> PROGRAM->
PROGRAM->
LiFe LiFe LiFe LiFe LiFe
V.Type 3.3V
V.Type 3.3V V.Type 3.3V V.Type 3.3V V.Type 3.3V
LiPo/LiIo/LiFe LiPo/LiIo/LiFe LiPo/LiIo/LiFe LiPo/LiIo/LiFe LiPo/LiIo/LiFe
CHK Time 10min
CHK Time 10min CHK Time 10min CHK Time 10min CHK Time 10min