2
Activate auto-power off
• Restart the device by setting the function dial OFF then ON again.
• The symbol will show.
e) Relative value
This stores an existing reading (a delta) and resets the display to zero. It is a relative reference
point to measure against the next reading.
• This mode is only applicable with the following functions: V , V , µA , mA , A ,
ACmV, Ω, .
• Short press the REL button to enter or exit REL measurement function.
• The symbol will show.
13. Replacing the Fuse
Never operate the meter if the case is open. !DANGER TO LIFE!
1. Turn the function dial to the “OFF”
position.
2. Remove the test leads from the input
terminals.
3. Unscrew then remove the battery
cover.
4. Unscrew the rear cover screws.
5. Replace the fuse with one that is of the
same type and specification. Refer to
the section “Technical data” for further
information.
6. Carefully replace the covers.
54