w w w . v o l t l i g h t i n g . c o m
INSTALLATION INSTRUCTIONS
VOLT
®
Floodlight with Motion Sensor
VFL-40XX-MS-LI-ABZ
[email protected] • 813.978.3700
Infrared (IR) Sensor (Continued)
Max 39.4 Ft.
180
。
Ma
x 39.4 Ft.
1.64 Ft.
6.56~11.48 Ft.
3
2
1
Last, turn on the power and check if the lighting fixture works.
Detection distance: max. 39.4 feet
Detection angle: 180°
Optimal installation height:
6.56 - 11.48 feet
Operating humidity:< 93% RH
1. LUX: 0-2000 lux twilight sensor
sensivity adjustable.
a. When set at maximum
(towards the sun) the
motion sensor works even in
the day time.
b. When set at minimum
(towards the moon) the
motion sensor works only in
the dark.
2. TIME: From 7 sec to 15 min. adjustability
a. At the maximum setting, the fixture is illuminated 15 minutes
after the sensor is triggered.
b. At the minimum setting, the fixtured is illuminated 7 seconds
after the sensor is triggered.
3. SENS: If the sensor is too sensitive or not sensitive enough, it can be
adjusted here.
Replace IR Sensor
1
Remove Backing with IR Sensor
Rotate the bracket so that
the backing can easily be
removed from the fixture.
Remove the backing with IR
sensor from the fixture by
loosening the screws.
Use pliers to squeeze the
connectors and release
wires.
Bracket
Backing
Fixture
Screw
IR Sensor
Supply Cable
Connectors
Wires
2
Remove/Replace IR Sensor
Unscrew the lock screw from
the knuckle and remove the
IR sensor from the back of
the fixture.
Place the wires of the
replacement IR sensor inside
of the back by passing wires
through the knuckle. Then,
connect the replacement
sensor to the back by using
the previously removed lock
screw. Hand tighten until
snug.
Back
IR Sensor
Supply Cable
Lock Screw
Wires
