Vollrath STOELTING Flavor Burst STL-80BLD, Operator'S Manual

Page: 62 / 76

59
4. Behind the freezer, locate the large hole in
the top of the cart. Feed the 9-Tube
Assembly tubes, the Touch Panel ethernet
cable, and the Drive Motor cable through
the hole and into the cart.
5. Examine the rear cart panel with electronics
board that came with your Flavor Burst
system. Locate the pump harness port
(BANK A / PWRCONN2), the Drive Motor
port (BANK C / PWRCONN4), and the
ethernet port. Keep the panel close to the
cart as you connect the cables in the next
steps.
6. Find the pump harness cable under the
pumps and carefully lead it through the cart
shelf opening. Connect the harness to the
port on the electronics board labeled “BANK
A” or “PWRCONN2”.
7. Connect the end of the Drive Motor cable to
the port on the electronics board labeled
“BANK C” or “PWRCONN4”.
8. Connect the end of the Touch Panel
ethernet cable to the ethernet port on the
electronics board.
9. Locate the 9-Tube Lead under the pumps
and lead it through the cart shelf opening.
Remove the dust cap.
10. Ensure the 9-hole gasket is placed between
the Lead and the 9-Tube Assembly coupler
pins. The gasket must be in place to seal
the connection and prevent leakage.