44
9-Tube Assembly Syrup Lines
1. If it is necessary, follow instructions in
‘Phase 1’ and ‘Phase 3’ of the Clean-In-
Place procedure to clean and sanitize the
coupler body, syrup line manifold, and the
duckbill check valve.
2. Clean the coupler base, the end of the
manifold and the outside of the syrup tubes
with a towel and detergent water.
3. Rinse the parts using a single service towel
and warm water (108°F / 42°C), then dry
with a towel.
4. Reassemble the 9-Tube Assembly if
necessary according to instructions in
‘Phase 4’ of the Clean-In-Place procedure.
Touch Panel and Mounting Bracket
NOTE:
DO NOT GET WATER NEAR THE
CABLE CONNECTIONS OR SPEAKER
HOLES ON THE TOUCH PANEL.
NOTE:
DO NOT USE ANY HARSH
CHEMICAL CLEANERS, BLEACH, AMMONIA,
EXCESS WATER, BRUSHES OR ABRASIVE
TOOLS TO CLEAN THE SURFACE OF THE
TOUCH PANEL. THESE MAY DAMAGE THE
SURFACE OF THE SCREEN AND VOID THE
PANEL’S WARRANTY.
1. Turn the Touch Panel off by pressing the
power button on the back side of the Panel.
2. Use only clean soft cloths, such as micro-
fiber cloths, to clean the Touch Panel
surfaces. Dampen a soft cloth with warm
water (108°F / 42°C). Wring out any excess
moisture from the cloth.
3. Gently wipe the surfaces of the Touch Panel
and mounting bracket to remove dust, dirt,
fingerprints, etc.
4. Gently wipe the cables with the dampened
cloth, taking care not to get any moisture
near cable connections and any openings
on the Touch Panel.
5. Use the dry soft cloth to dry the surfaces of
the Touch Panel and cables.
Summary of Contents for Stoelting Flavor Burst STL-40BLD-JR
