12
When connecting hoses to your
LaundryPure 2 0 hand start the hose
connector(s) Using adjustable pliers, finish
tightening hose connector(s)
CAUTION:
Some washing machine models require water pressure to both the Hot and Cold valves for
proper operation In some cases, if only the COLD water side is connected, the water valve
will not operate or the washing machine will not fill to the proper level To solve this problem,
the installation of a “Y” adapter (available at most hardware stores) may be used The use of
the “Y” adapter allows water to flow equally through both the HOT and COLD water valves
Optional stainless steel hose (item #: 49701-US) must be installed on the hot water connection
To Install, turn water off at the valves and disconnect the existing HOT water hose (at the valve
and washing machine) Connect the “Y” adapter to the outlet on your LaundryPure 2 0, then
connect both the optional stainless steel hose (item #: 49701-US) and Cold hose from your
washer to the “Y” adapter (see diagram below) Operate your washer on the WARM/WARM
setting (your LaundryPure 2 0 will still be using just cold water)
Turn off both water valves (hot and cold)
before disconnecting hoses Failure to
follow these instructions may result in
water leakage and/or possible injury
from hot water
CAUTION:
NOTE:
Your hot source water valve will not have a hose connected to it
Make sure it is fully turned off It is recommended you secure a cap
(available at most home improvement stores) to prevent leakage
NOTE:
The “Y” adapter needs to be purchased locally Use only a metal adapter
DO NOT
use plastic
FOR WASHERS THAT REQUIRE HOT & COLD WATER INPUT
Connect to household
plumbing
COLD
water valve
“Y” adapter
Make sure the “Y” adapter
valve is in the on position
NOTE:
Use a metal “Y” adapter
Do not use plastic
Connect to
HOT
water inlet
on washing machine
Connect to
COLD
water inlet
on washing machine
Disconnect the existing hose
from the HOT valve and washing
machine and remove Replace
with optional stainless
steel hose Part No
49701-US
(not included)
Disconnect this stainless steel hose from
the
OUTLET
on your LaundryPure 2 0,
then connect it to the “Y” adapter
Connect the “Y” adapter to the
OUTLET
on your
LaundryPure 2 0 Be sure to hold the fitting with
pliers while tightening the adapter
Stainless steel hose supplied
with LaundryPure 2 0
