VOLKTEK NSH-580 MANAGED 24-PORT 10/100 + 4 G COMBO L3 SWITCH
loadbx
none
none
load binary file over serial line (X modem)
netmask
mask
xxx.xxx.xxx.xxx
set network mask
ping
host
xxx.xxx.xxx.xxx
send ICMP ECHO_REQUEST to network host
pwd
none
none
reset switch password
reset
none
none
perform reset of the CPU
serverip
IP address
xxx.xxx.xxx.xxx
set tftp server IP address
slot
slot
1, 2, auto
select boot slot to boot
tftpboot
filename
Example:
3112single.img
load image via network using TFTP protocol
version
none
none
print monitor version
Boot ROM commands
8.2
Login and Logout
To enter the CLI mode, a valid user name and password must be entered. For the first
login, the user can enter “admin” as the user name (without password). For security
reasons, please change the user name and password after login. If you forget the user
name and password, you may contact the support team or restore the default user
account in the Boot ROM Command mode – “pwd”. If you select the second choice, the
default username “admin” will be restored.
Type “exit” to leave the CLI mode safely. This action allows the user to secure the CLI
mode. The next user has to log in again with an authorized user name and password.
8.3 CLI
Commands
The Switch provides CLI commands for all managed functions. The user can follow the
instructions and set up the switch correctly as easily as using WEB interface to configure
the switch.
Note: Always use “?” or “list” to get the available commands list and help.
Always use “end” to get back to the root directory (enable mode).
8.3.1 User
Account
8.3.1.1 Add
user
Add a new user or modify an existing user’s password.
CLI Syntax:
add user user-name password
Example:
Switch(config)#add user admin 123
79
