Warning!
After disconnecting and reconnecting the battery,
pinch protection of the power window regulators will
not function. This can cause serious injuries if e.g.
fingers are caught in the window!
Perform the following work sequence to position the
electric windows:
Note:
The following work sequence is for the front left
window. The positioning for the remaining windows
is performed in the same manner using the
respective switch in the drivers door.
- Switch ignition on.
- Close all doors and windows completely.
- Hold left front side-window in position "Close" by pulling
and holding switch for longer than 1 second.
- Lift button again for 1 second. Now when the button is
pressed briefly the window will lower fully and when the
button is lifted briefly the window will raise fully.
- Switch off ignition
Vehicle system test, perform
- Connect diagnostic tester
01-3, Diagnostic unit,
connecting
.
- Switch ignition on.
- Select operating mode "Guided Fault Finding" on the
display.
- Then perform vehicle identification on tester.
Program now performs a vehicle system test automatically
and checks for all possible control modules for this vehicle
type.
- Press Continue > button.
Now all DTCs will be listed.
Note:
At this point it makes sense to switch into operating
mode Guided Functions in order to perform further
work using VAS 5051/5052 and to prevent a second
Page 18 / 37
Description of work (part 1 of 2)
