Installation Instructions
26
User Manual CPM II2066en Rev. C
© BTG 2020
3.1.3.5
Communication Module CCM-8200
On CCM-8200 the ethernet interface RJ-45 connector is located at position 1.
The USB connector P2 and the connectors P3 - P5 are for future options l
The ethernet cable to the CCM-8200 interface must go through the designated
cable gland as shown below.
P1
P2
P1
P2
P3
P3
Eth
WiFi
Status
P4
P5
P4
P5
Fig 21 Communication
Module CCM-8200
1. P1 RJ-45 connector
2. P2 USB connector
(for future options)
3. P3 connector
(for future options)
4. P4 connector
(for future options)
5. P5 connector
(for future options)
The status of the LEDs
Status
On
Power is on
Flashing
Instrument communication
Eth
On
Ethernet link has been established
Flashing
Ethernet traffic
WiFi
On
Connected to WiFi access point
Fig 22 Ethernet cable to
CCM-8200
Summary of Contents for BTG CPM-1300
