28
Subject to change without notice
Contact:
+49(0)92 78-774 33-0
+49(0)92 78-774 33-11
www.vogt-tec.de
Removing a tool
Connect the hose to the compressed air source (e.g. compressor) and open
the compressed air supply.
Check that the compressed air hoses and couplings are tight.
In the case of leakages, interrupt the compressed air supply and replace the hose!
3.2 Connecting the hose
C
Slide the sliding sleeve (C) halfway downwards.
A
B
Pull out the tool (A) using your other hand.
Return the sliding sleeve to its original position.
Connect the hose to the VOGT compressed air equipment. When doing so,
ensure that the compressed air equipment does not switch on automatically.
If this happens, disconnect the compressed air coupling immediately. Have
the compressed air equipment repaired at a specialist workshop or by the
manufacturer.
Risk of injury from tools flying out.
Every time you change tools, ensure that the tool holder does not show signs of heavy
wear or heavy denting. Furthermore, ensure that the hexagon on the tool is in perfect
condition. Ensure that the tool is fitting correctly each time you change tools.
NOTE
EN
