16
Re-syncing the Wireless Mics
Occasionally the microphone will need to be re-synced with the respective module. The frequency is the same but the
connection between mic and module is lost.
Note: Please read through the steps before attempting to sync the microphones. The module menus have a 4 second timeout
period where if a button is not pressed within that time the module will revert back to the frequency information page.
1 . Prepare the system: Ensure the receiver base, the desired
module to be paired, and the desired microphone to be
paired, are all powered on.
2 . Identify the IR Sensors: Locate the IR Sensor on both
microphone and module .
A.) Microphone - The IR Sensor is located just above the
ON/OFF switch.
B.) Module - The IR Sensor is located directly below the
module volume knob.
3 . Align the IR Sensors: Position the microphone so that the
2 IR Sensors are level within 3-5 inches of one another.
4 . Re-sync Microphone: Press the MENU button on the
desired module for time (4x) to cycle the menu to IR
mode; this will display the IR symbol. With the IR symbol
displayed, press the SET button to communicate the
existing frequency to the microphone. This will display
waves emanating from the IR symbol, when the waves
disappear, the screen will display the existing frequency, as
well as the AF and RF reception bars for that channel.
5 . Test the Mic: Speak into the microphone to ensure sound
is being produced and transmitted . The AF bars on the
LCD should register as the microphone is spoken into.
Note: Once the microphone and module are synced, there will be a
5 second delay in audio when the microphone is powered on. This is
normal.
3
wireless
microphone
SET
UHF-8900
IR
VOL
UHF PLL WIRELESS SYSTEM
WITH FREQUENCY SCAN
MENU
5
SET
UHF-8900
IR
VOL
UHF PLL WIRELESS SYSTEM
WITH FREQUENCY SCAN
MENU
SCAN
4
UP
DOWN
IR MODE
