23
SDR-3 Installation
1. Unscrew the two retaining screws.
2. Remove plate and store it in a safe place.
3. Attach the cable to the back of the SDR-3.
4. Carefully slide the SDR-3 into place.
5. Replace and tighten screws.
Inserting/Removing an SD card
1. Insert SD card with the same alignment as
indicated by the SD card icon.
2. Push the SD card unit it clicks into place.
3. To remove the SD card, gently push in until it
pops out slightly; it is then safe to remove.
NOTE: The maximum size SD card that can be
used by the SDR-3 is 1GB. The SDR-3 does not
support SDHC cards.
SDR-3 Operations
Recording to the SDR-3
Prior to recording to the SDR-3, you want to ensure that the signal being recorded is properly mixed. Refer
to the text on “REC LEVEL LEDs” to ensure a good level. Once you are happy with your overall mix, follow the
steps below to record.
In stop mode, press the REC button once to place the SDR- 3 in record pause mode. This is the time to
check the levels of the audio to be recorded and adjust the REC VOL control if necessary.
Press the REC button a second time to begin recording.
Pressing the REC button during a recording in progress will pause the recording without creating a new
track. This is useful for recording several sections of a recording session into a single cohesive track
without breaking it up into several tracks.
