17
Top Panel
Descriptions and Functions
CHANNEL 1-3 STRIPS
9.
XLR-1/4” jack
– These combo-jacks are for connecting microphones, music instruments, and line-outs from mixers.
Connect cables with a ¼” plug into the center of each jack. Connect cables with an XLR plug into the outer ring of
each jack.
NOTE: Refer to the text below on setting the +48V and 30dB PAD buttons to match your connected device.
10.
+48 button
– Use this button to enable and d48V power to connected microphones. Only set this button to
the ON position when using a condenser microphone connected with an XLR cable.
11.
30dB PAD button
– Use this button to provide a 30dB signal cut to the incoming audio signal. Some devices have
higher level signals than others. Higher level signals need to be cut in order to prevent overloading. If you notice a
channel’s sound has static (is over-modulated), set the switch to ON. Otherwise set the switch to OFF.
12.
TREBLE knob
– Use this knob to increase or decrease high frequencies for channels 1-3. Increasing treble adds
sparkle to the audio. To increase treble, turn the knob clockwise. To decrease treble, turn the knob counter-
clockwise.
13.
BASS knob
- Use this knob to increase or decrease low frequencies for channels 1-3. Increasing bass adds low-end
punch to the audio. To increase bass, turn the knob clockwise. To decrease bass, turn the knob counter-clockwise.
14.
EFFECTS knob
– Use this knob to increase or decrease the amount of effects applied to each channel. This allows
one channel to have more effects than another channel. To increase bass, turn the knob clockwise. To decrease
bass, turn the knob counter-clockwise.
0
L
R
MOBILEMAN
9
10
11
13
12
14
