20
Basic Operations
Using the AM/FM Tuner
To use the AM/FM Tuner:
1. Connect the AM and/or FM antenna to the rear
panel of the HERO-RV.
2. Power on the HERO-RV.
3. Select Tuner using the Input Select Buttons. The
display screen should display “Tuner”.
4. Select AM or FM using the AM/FM button on the
front panel or remote control.
5. Use the search buttons or preset buttons to tune
to a radio station, and adjust volume to the desired
level.
There are 20 station presets available.
To set radio station presets:
1. Use the search or auto buttons to tune to a radio
station.
2. Press and hold one of the preset number buttons
on the front panel for 2 seconds. The tuned radio
station will now be set to this preset number.
3. Repeat the process for additional station presets.
To set radio station presets above the number 10:
1. Tune to the desired station.
2. Press the +10 button and then hold one of the
preset numbers for 2 seconds.
For example, to program preset 14: press +10
then hold number 4 for 2 seconds.
To set preset 20: Press +10 then hold number 0
for 2 seconds.
To use radio station presets:
1. Press any of the number buttons on the front panel
to jump to a preset radio station.
2. For presets above number 10, press the +10
button, then the preset number.
For example, to jump to preset 14: Press +10
then number 4.
To jump to preset 20: Press +10 then number 0.
Removing a Wireless Module
The Wireless modules are designed to be easily removed
and installed in case it requires service.
To remove a wireless module:
1.
Turn the HERO-RV OFF, and unplug the power
cable.
2. Remove the two screws that hold the module in
place.
3. Carefully slide the module out.
4. Carefully detach the connector cable.
NOTE:
Make sure the cable does not fall back into
the unit. It may be necessary to temporarily secure
the cable to the unit with tape while there is no
module in the slot.
Installing a Wireless Module
The Wireless modules are designed to be easily removed
and installed in case it requires service.
To install a wireless module:
1.
Turn the HERO-RV OFF, and unplug the power
cable.
2. (If the slot cover is already removed, skip to step 4)
Remove the two screws that hold the slot cover in
place.
3. Carefully detach the connector cable from the slot
cover.
NOTE:
Make sure the cable does not fall back into
the unit. It may be necessary to temporarily secure
the cable to the unit with tape while there is no
module in the slot.
4. Carefully connect the connector cable to the
module. The cable plug is designed to fi t only one
way, if it does not fi t correctly, fl ip the plug over and
try again.
5. Carefully slide the module into the slot.
6. Secure the module with the two screws.
